Output images same as input (filters not being applied)
Posted: Sat Nov 02, 2019 4:19 am
Today, I updated to BatchPhoto Pro v4.4 and my work was going well. Then after a few hours, I began to have a problem where my output images where the same as my input images. It appears that the filters were not being applied. The problem is intermittent: sometimes it happens sometimes it doesn't. I've restarted BatchPhoto Pro several times and rebooted my Win 10 computer twice.
I've tried different images (all .jpg), in different input directories, applied a variety and quantity of filters, and sent the output .jpg images to different directories and the result is always the same: sometimes the filter is applied, sometimes not. I haven't detected a pattern to this problem.
I did find this problem mentioned on this forum several years ago, but there was no solution.
Any ideas would be appreciated.
I've tried different images (all .jpg), in different input directories, applied a variety and quantity of filters, and sent the output .jpg images to different directories and the result is always the same: sometimes the filter is applied, sometimes not. I haven't detected a pattern to this problem.
I did find this problem mentioned on this forum several years ago, but there was no solution.
Any ideas would be appreciated.