Page 1 of 1

Upgrade Failure

Posted: Sun May 14, 2017 1:25 pm
by asg
I needed to upgrade to to batch process, which I was not told I had to, and I CANNOT USE IT TO ALTER RGB!! IT STILL GRAYS OUT THE OPTION TO BATCH PROCESS THE PHOTOS!

Re: Upgrade Failure

Posted: Mon May 15, 2017 7:13 am
by Cosmin

I'm sorry to hear about your problems.

We have three editions of BatchPhoto and you have purchased the lowest one (Home). Here is a detailed comparison chart between the editions:

Now, after upgrading to Pro all the Touch-Up filters should have been enabled. Did you activate the Pro version?

If not, open BatchPhoto and from the main menu select Help > Activate > Update Code, then copy & paste your Pro code and click OK.

Let me know if this solves your problem.